*
* NEC IX2107
* S/N : E8THU05990
*
* ! No password
*
NEC Diagnostic Software
Copyright (c) NEC Corporation 2001-2023. All rights reserved.
%DIAG-INFO: Starting System POST(Power On Self Test)
DRAM TEST 1: Pass
DRAM TEST 2: Pass
CPU TEST: Pass
PLD TEST: Pass
RTC TEST: Pass
GE0 TEST: Pass
GE1(SW-HUB)1-4 TEST: Pass
1.0 VOLTAGE STATUS: 0.987V Pass
1.35 VOLTAGE STATUS: 1.297V Pass
2.5 VOLTAGE STATUS: 2.418V Pass
3.3 VOLTAGE STATUS: 3.234V Pass
5.0 VOLTAGE STATUS: 4.914V Pass
TEMPERATURE STATUS: +26.0degC Pass
NEC Bootstrap Software
Copyright (c) NEC Corporation 2001-2023. All rights reserved.
%BOOT-INFO: Trying flash load, exec-image [ix2107-ms-10.8.21.ldc].
Loading: ######################################################
NEC Bootstrap Software, Version 3.1
Copyright (c) NEC Corporation 2001-2023. All rights reserved.
boot[0]> cc
Enter "Y" to clear startup configuration: Y
% Startup configuration is cleared.
NEC Bootstrap Software, Version 3.1
Copyright (c) NEC Corporation 2001-2023. All rights reserved.
boot[0]> b
NEC Bootstrap Software
Copyright (c) NEC Corporation 2001-2023. All rights reserved.
%BOOT-INFO: Trying flash load, exec-image [ix2107-ms-10.8.21.ldc].
Loading: ######################################################################################################################################## [OK]
Starting at 0x20000
Configuring router subsystems (before IDB proc): done.
Constructing IDB(Interface Database): done.
Configuring router subsystems (after IDB proc): done.
Initializing router subsystems: done.
Starting router subsystems: done.
All router subsystems coming up.
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
WARNING! Administrative username is not configured!!
Action: Please configure administrative username.
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
NEC Portable Internetwork Core Operating System Software
Copyright Notices:
Copyright (c) NEC Corporation 2001-2023. All rights reserved.
Copyright (c) 1985-1998 OpenROUTE Networks, Inc.
Copyright (c) 1984-1987, 1989 J. Noel Chiappa.
Router#
Router# config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Router(config)# show ver
NEC Portable Internetwork Core Operating System Software
IX Series IX2107 (magellan-sec) Software, Version 10.8.21, RELEASE SOFTWARE
Compiled Jun 20-Tue-2023 12:22:12 JST #2 by sw-build, coregen-10.8(21)
ROM: System Bootstrap, Version 3.1
System Diagnostic, Version 3.1
Initialization Program, Version 3.1
System uptime is 0 minute
System woke up by reload, caused by power-on
System started at Sep 22-Mon-2025 15:45:08 JST
System image file is "ix2107-ms-10.8.21.ldc"
Processor board ID <0>
IX2107 (P1010E) processor with 524288K bytes of memory.
2 GigaEthernet/IEEE 802.3 interfaces
1024K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
Router(config)#
Router(config)# show environment
System hardware information:
Line voltage:
1.0 volt line measured at 0.9870V
Status is normal
1.35 volt line measured at 1.2972V
Status is normal
2.5 volt line measured at 2.4180V
Status is normal
3.3 volt line measured at 3.2336V
Status is normal
5.0 volt line measured at 4.9140V
Status is normal
Internal temperature:
Internal temperature measured at 29.0C
Status is normal
Router(config)#
Router(config)#
Router(config)# show hardware
IX Series IX2107 Hardware Platform
S/N: E8THU05990
ZTP<0>:
ZTP ID : 549B49DDE77F#IX#IX2107#E8THU05990
Status : stopped
Next boot mode : normal mode
Processor board:
Processor board ID <0>
CPU/DDR3/CSB/LBUS clock frequencies are 800/800/400/100 MHz
P1010E processor (revision 0x80f90020)
524288K bytes of main memory
1024K bytes of non-volatile configuration memory
32768K bytes of processor flash memory <0>
IPsec accelerator:
on board security engine(SEC4.4), revision 0x100
Onboard interface unit GigaEthernet0:
GigaEthernet Transceiver is 88E6352
Onboard interface unit GigaEthernet1:
GigaEthernet Switch with Transceivers is 88E6352
LED information:
PWR: On ALM: Off BSY: Off
VPN: Off PPP: Off BAK: Off
MODE: Off
Switch position:
MODE: OFF
Router(config)#
Router(config)# show license
IPsec H/W encryption is activated
VRRP option is activated
Router(config)#
Router(config)#
Router(config)# show vlans
GigaEthernet1 Virtual Bridged LAN
Group N/A status is down
Assigned ports: 1 2 3 4
0 input frames, 0 output frames
Router(config)#
Router(config)#
Router(config)# show error-log
0% flash memory used, 126976 bytes free, total 126976 bytes
Latest Occurrence Time Event Description
2024/08/29 13:01:58 +0900 INFO: Start logging fault and crash errorlog_information
2025/09/22 15:44:54 +0900 INFO: Start bootstrap from this side [0].
2025/09/22 15:44:52 +0900 INFO: Erase startup-config cmd:cc state:succeeded from:@local
2024/10/07 18:22:06 +0900 INFO: Modify startup-config cmd:write state:succeeded from:provi@157.205.79.99
Router(config)#
Router(config)# show crashinfo
0% flash memory used, 126976 bytes free, total 126976 bytes
Latest Occurrence Time Event Description
2024/08/29 13:01:58 +0900 INFO: Start logging fault and crash errorlog_information
2025/09/22 15:44:54 +0900 INFO: Start bootstrap from this side [0].
2025/09/22 15:44:52 +0900 INFO: Erase startup-config cmd:cc state:succeeded from:@local
2024/10/07 18:22:06 +0900 INFO: Modify startup-config cmd:write state:succeeded from:provi@157.205.79.99
Router(config)#
Router(config)#
Router(config)# show config
% Non-volatile configuration memory is not present
Router(config)#
Router(config)#
Router(config)# show log
% Buffer logging disabled.
Router(config)#
Router(config)#
Router(config)# exit
Router#